XENO+ LTE+GPS Nano CPU Module is a solderable module and can be used as core CPU module of any new IOT devices design of customers so that customers can focus only on adding sensors and power circuits around this CPU module for building their new IOT devices in short time.

This module readily supports LTE-Cat1, EDGE, GPRS & SMS and GPS along with both Nano SIM slot and e-SIM provisions

The module has smallest possible size with STM32L4 series ARM Cortex-M4, 1MB Flash, 352KB/128KB RAM, UART/SPI/I2C ports and GPIOs. This module has USB Type C based 5V Power input with serial debug port and Battery power input options. This module has 3 pin SWD pins for SW development and SW debug via STM32CubeIDE for Embedded SW development for the device by the users.

LTE+GPS CPU Module Overview

The below table shows the brief overview of modules:

Product Features and Specifications:

The XENO+ ™ module product features and specifications are listed below:

Table-1: The Product features and specifications

Module Pinouts:

This module has 18x18 Castellated pins. The Left side 18 pins mapping and Right side 18 pins mapping are listed below. The MCU port pins can be assigned with 2 predefined module functions: Function-A and Function-B. The users can also map custom functions as per STM32L4 native GPIO functions on these pins.

Left side 18 pins connector signals:

Right side 18 pins connector signals:

Module Layout and Dimensions:

This module layout and dimensions are shown below.

Module Dimensions (in mm)

Documentation:

XENO+ ™ LTE+GPS Nano CPU Module STM Based Datasheet